Normally Open, increasing pressure closes 110-440 psi spring range for accurate control Internally sensed Simple adjustment All parts replaceable while mounted on valve Rubber to metal seat for positive shut-off Stainless Steel construction Water service only The Model 2490 is a three-way, normally open pilot, that senses pressure under its diaphragm and balances it against an
LCD display for easy selection and adjustment of programming**Programming includes days of the week, odd/even, interval and freeze delay (1-99 days) Length of activation 1 min to 12 hours Provides programmable valve operation (open/close) Available in weatherproof enclosures Lithium battery powered (internal) Available in nylon reinforced ABS plastic The two-way solenoid is a valve that
Bottom-mount flange (7.5″ diameter) Integral water drain valve optional Pilot float “rides” the interface between water and fuel Four-way control to actuate discharge slug valve and/or automatic water drain valve Uses time-proven 800 pilot block (see Model sheet 800) Stainless Steel pilot and float assembly Manual tester standard Factory tested The Model 800B is
Used on all OCV filter separator float controls Accurate and responsive movement to rising water Low friction operation Pressure balanced design Resilient seating resists le akage Four-way control to actuate discharge slug valve and/or automatic water drain valve No lubrication necessary Unique, time-proven design Factory tested All-Stainless Steel construction The model 800 pilot block is
Bottom-mount flange (10″ diameter) Low profile float Applicable where vertical clearance inside filter separator is limited Integral water drain valve optional Pilot float “rides” the interface between water and fuel Four-way control to actuate discharge slug valve and/or automatic water drain valve Uses time-proven 800 pilot block (see Model Sheet 800) Stainless Steel pilot and
Side-mount flange fits most brands of filter separators Pilot float “rides” the interface between water and fuel Four-way control to actuate discharge slug valve and/or automatic water drain valve Uses time-proven 800 pilot block (see Model Sheet 800) Stainless Steel pilot and float assembly Manual tester standard Factory tested The Model 800D is a side-mounted
Side-mount flange, 4″ grooved connection Cylindrical float Pilot float “rides” the interface between water and fuel Four-way control to actuate discharge slug valve and/or automatic water drain valve Uses time-proven 800 pilot block (see Model Sheet 800) Stainless Steel pilot and float assembly (no red metals) Manual tester standard Factory tested The Model 800C is
Ballasted manual tester verifies integrity of the float ball Side-mount flange fits most brands of filter separator Pilot float “rides” the interface between water and fuel Four-way control to actuate discharge slug valve and/or automatic water drain valve Uses time-proven 800 pilot block (see Model Sheet 800) Stainless Steel pilot and float assembly (no red
Normally Open, increasing pressure closes 50-165 psi spring range for accurate control Internally sensed Simple adjustment All parts replaceable while mounted on valve Rubber to metal seat for positive shut-off Bronze or stainless steel construction Water service only The model 1390 is a three-way, normally open pilot that senses pressure under its diaphragm and balances
The two-way solenoid is a valve that opens and closes flow depending upon the electrical state of the coil. Installed in the valve pilot circuit, it controls the valve to open or close. The solenoid can be installed in series with a hydraulic control pilot to override the pilot and close the valve (e.g., OCV